How To Measure With Cursors - Vevor Sds1102 Benutzerhandbuch

and the unit is voltage-second. The area measured above the
zero reference (namely the vertical offset) is positive; the area
measured below the zero reference is negative. The area
measured is the algebraic sum of the area of the whole
waveform within the screen.
Cycle Area
the screen and the unit is voltage-second. The area above the
zero reference (namely the vertical offset) is positive and the
area below the zero reference is negative. The area measured is
the algebraic sum of the area of the whole period waveform.
Note: When the waveform on the screen is less than a period,
the period area measured is 0.

How to Measure with Cursors

Push the Cursor button to turn cursors on and display the cursor
menu. Push it again to turn cursors off.
The Cursor Measurement for normal mode:
The description of the cursor menu is shown as the following
table:
Functio
n Menu
Time&Volta
Type
AutoCursr
: The area of the first period of waveform on
Setting Description
Voltage Display the voltage measurement cursor
Time and menu.
Display the time measurement cursor
ge and menu.
Display the time and voltage
measurement cursor and menu.
The horizontal cursors are set as the
intersections of the vertical cursors and
the waveform
70