OPERATING MANUAL
Mounting screw version
This type of mounting requires the parts pro-
videdforthescrewversionofRotoclearS3.
Drilling and tightly clamping the polycarbon-
ate pane may affect the properties of the pane.
Have the installation carried out by qualified per-
sonnel. Adhere to the tightening torques and
observe the clamping range of the screw-
mountedflange.Inthecaseofoldpanesoraftera
long period of use, look out for cracks and cloud-
ing on the machinery glass. Replace the pane in
good time.
Due to the impact resistance values obtained
inballistictests,thescrewversionofRotoclear S3
is not to be used in combination with lathes or
grinding machines. In such cases, you must install
thebondingversionofRotoclearS3.Fasteningby
means of a hole circle is only used on milling
machines and centers with polycarbonate discs.
For more information, please refer to the section
"Intendeduse".
Mounting steps
The following steps take approximately one hour
in total.
Drill a hole circle in the polycarbonate disc
using the dimensions shown in Figure 5, adapted
to the desired orientation of the connection box.
For this, use the enclosed drilling template and
drill bits suitable for polycarbonate. Blunt drill bits
can negatively impact the drilling result and pro-
mote the formation of cracks. These can also form
at a later time if the drilling results are imperfect.
Clean the inside and outside of the pane (Fig.
4-A) thoroughly with isopropyl alcohol.
Align the logo cap (Fig. 4-A) according to the
desiredorientationoftheconnectionbox.
We recommend using polycarbonate-com-
patible plastic sleeves (max. outside diame-
ter 8.5 mm, inside 7 mm, length max. 14 mm)
that are pushed onto the 10 bolts of the screw
flangebeforeassembly.Thisisagentlemeasure
that minimizes the risk of cracks forming in the
machine's protective screen. These sleeves are
not included.
Insert the screw-mounted flange (Fig. 4-B)
into the holes of the pane from the outside and
fix it in place temporarily, e.g. using residue-free
adhesive tape, so that it does not fall out when the
stator is attached.
256
10 x
10
Figure 5
Once the stator (Fig. 4-C) with inserted seal-
ing ring (Fig. 4-D) has been attached, screw in the
M5×20Tx10screws(Fig.4-E)andtightenthem
with a torque of 1.1 Nm.
64
10 x 36°