Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation guide / User manual
AX Plus 5-15kW 3ph Hybrid Inverter
5.3 Mounting
Installation Precaution
Make sure the installation site meets the following conditions:
• Not in direct sunlight.
• Not in areas where highly flammable materials are stored.
• Not in potential explosive areas.
• Not in the cool air directly.
• Not near the television antenna or antenna cable.
• Not higher than altitude of about 2000m above sea level.
• Not in environment of precipitation or humidity (>95%).
• Under good ventilation condition.
• The ambient temperature in the range of -25°C to +60°C.
• The slope of the wall should be within +5*.
• The wall hanging the inverter should meet conditions below:
A
Solid brick/concrete, or strength equivalent mounting surface;
B
Inverter must be supported or strengthened if the wall's strength
isn't enough (such as wooden wall, the wall covered by thick layer of
decoration).
Please avoid direct sunlight, rain exposure, snow laying up during installation
and operation.
Not direct
sunlight
Space Requirement
Page 90
No rain
No snow build
exposure
✕
✕
Direct sunlight
Rain exposure
Position
Links
Rechts
Oben
Unten
✕
Snow lay up
Min Distance
300 mm
300 mm
500 mm
500 mm
atx054en0225
Werbung
