Scheppach HS210 Originalbetriebsanleitung Seite 47

18. Troubleshooting
The following table shows fault symptoms and describes remedial measures in the event of your product failing to
work properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault
Saw blade is loose after
the motor is switched
off
Engine does not start
Motor not supplying
power, fuse tripping
Burnt areas on the
cutting surface
Incorrect motor
rotational direction
Possible cause
Fixing nut not tight enough
Mains fuse blown
Extension lead defective
Connection to the engine or switch
not OK
Engine or switch faulty
Cross section of the extension cable
insufficient
Overload due to blunt saw blade
Blunt saw blade
Incorrect saw blade
Capacitor defective
Incorrect connection
www.scheppach.com
Remedy
Tighten fastening nut, right-hand thread
Check mains fuse
Replace the extension lead
Have this checked by an electrician
Have this checked by an electrician
see "Electrical connection"
Replacing the saw blade
Have an authorised sharpening service
sharpen the saw blade or replace it
Replace saw blade
Have this checked by an electrician
Have an electrician transpose the wall
socket poles
GB | 47