KKT KOLBE HKW10-1P3 Benutzerhandbuch Seite 202

Connecting the Device
Gridconnectionstepsfortheinstaller
• Make the EPS wiring as follows:
• Select a suitable cable (see corresponding table
under "Requirements..." in this section).
• Remove 10 mm of the insulation from the end of the
cable (1).
• Clamp the connections with crimping pliers.
• Disassemble the waterproof connectors and the
waterproof covers and pass the cable through the
waterproof connector (2).
• Connect the AC connection to the "EPS" port
of the inverter using a slotted screwdriver (4). (3 ;
top arrow Backup1, bottom arrow Backup2)
WARNING!
Risk of electric shock due to damage!
Be careful not to apply too much torque
when connecting with the screwdriver
to avoid damage to the feed-through terminals
and a resulting risk of electric shock.
The limit load when connecting the AC termi-
nals is 1.2 Nm.
92
1
2
3