KKT KOLBE HKW10-1P3 Benutzerhandbuch Seite 181

6.3 Error codes, meaning and suggested solutions
Code Meaning
00 DischgOverCur
(Discharg Over
Current)
01 Over Load
02 BatDisconnect
(Battery
disconnected)
03 Bat Under Vol
(Battery Under
Voltage)
04 Bat Low
capacity
(Battery low
capacity)
05 Bat OverVol
(Battery over
voltage)
Description Suggested solutions
Battery dis- • Wait one minute for the inverter to
charge over
current. When
• Check whether the load is in
the battery
is loaded, the
load is too
large.
The load power • Check whether the load is in compli-
is greater than
input powers
(PV,BAT).
• Disconnect the power supply to the
The battery • Check the battery connection and
voltage cannot
be identified.
The battery • Check the system settings.
voltage is lower
than the
normal range.
• Check whether there is a grid discon-
The capacity • Check the set battery capacity value.
of the battery
is low.
The battery • Check the system and battery parame-
voltage is higher
than the maxi-
mum voltage of
the inverter.
restart.
compliance with the specification.
ance with the maximum power of the
inverter.
loads, switch off the inverter and re-
duce the consumption.
Then restart the inverter and check
whether the fault has been eliminated.
wiring port and make sure that it is not
open circuited.
If they are correct, switch the device off
and restart it.
nection. If necessary, wait until it is
switched on again.
The DoD must be observed.
ter settings.
If they are correct, switch the device off
and restart it.
Troubleshooting
71