Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Further notes and symbols
CE Directives
This chapter follows the requirements of the European low voltage
directives, which contains the safety instructions and conditions of
acceptability for the entire system, which you must follow when installing,
operating and servicing the unit.
If ignored, physical injury or death may follow, or damage may occur to
the unit.
Read this before you work on the unit.
If you are unable to understand the dangers, warnings, cautions or
instructions, consult a suitably qualified electrician before installing,
operating or servicing the unit.
The grid connected inverter meets the requirement stipulated in re-
striction of hazardous substances (RohS), 2011/65/EU, Annex II and its
amendment (EU) 2015/863, Low Voltage Directive (LVD) 2014/35/EU and
Electromagnetic Compatibility (EMC) Directive 2014/30/EU.
The unit is CE compliant.
When installed in a PV system, startup of the unit (i.e. start of designated
operation) is prohibited until it has been determined that the full system
meets the requirements of CE.
The grid-connected inverter leaves the factory completely ready for con-
nection to the grid and the PV supply and is to be installed in accordance
with the national wiring regulations.
Compliance with safety regulations depends upon installation and
correct configuration of the system, including using the specified wires.
The system must be installed by professional assemblers who are famil-
iar with requirements for safety and EMC.
The assembler is responsible for ensuring that the end system complies
with all the relevant laws in the country where it is to be used.
The individual subassembly of the system shall be interconnected by
means of the wiring methods outlined in national/international such as
the national electric code (NFPA) No.70 or VDE regulation 0107.
18
Werbung
