Werbung
Verfügbare Sprachen
Verfügbare Sprachen
7.3 Mounting procedure
CAUTION!
Risk of injury!
Some components of the unit can be sharp-edged!
Protect yourself from injury during installation,
e.g. by wearing work gloves!
For installation on solid masonry (brick, concrete or similar),
proceed as described below.
If the unit is to be mounted on a different type of wall,
replace the fasteners mentioned according to the substrate.
Mounting the wall bracket
• Determine the desired position of the inverter,
taking into account the previously mentioned
distance regulations and dimensions.
• Place the wall bracket appropriately on the mounting
surface (use a spirit level for horizontal alignment if
necessary) and mark the positions of the 4 screw holes
(1).
• Drill 4 holes at the marked positions according to the
diameter of the dowels.
Make sure that the drill holes are deep enough to
support the inverter (at least 60 mm).
• Insert the expansion tubes into the drill holes (2) and
screw the bracket to them with the expansion screws
(3).
Mounting the Device
380mm
1
2
3
ø5mm
79
Werbung
