KKT KOLBE HKW10-1P3 Benutzerhandbuch Seite 164

Operation and Setting
Setting further operating setting parameters
Use the up/down keys
Use the enter key
or the escape key
to the selection of operating setting options.
Gridpower (GRIDPERCENT)
Specified as a percentage of the grid power.
Discharge (DISC PERCENT)
Specified as a percentage of the battery discharge
The following values are valid if the network standard
is set to "custom":
Low voltage protection point of the grid
(VAC-MIN/GRIDVOLTLOW)
Input value of grid low voltage.
Overvoltage protection point of the grid
(VAC-MAX/GRIDVOLTHIGH)
Input value of grid high voltage.
Low frequency protection point of the grid
(FAC-MIN/GRIDFREQLOW)
Input value of Grid low frequency.
Note:
For the German VDE network, the value 47 is recommended.
Overfrequency protection point of the grid
(FAC-MAX/GRIDFREQHIGH)
Input value of grid high frequency.
Note:
For the German VDE network, the value 53 is recommended.
Active parameters (ACTIVE REP.)
Only the default setting is allowed,
no further settings are necessary.
54
/ to adjust the input value.
to confirm your selection
to cancel the process and return
--GRID PERCENT--
INPUT: 100%
--DISC PERCENT--
INPUT: 100%
--GRID VOLT LOW--
INPUT: 150
UNIT:
--GRID VOLT HIGH--
INPUT: 280
UNIT:
--GRID FREQ LOW--
INPUT: 57.0
UNIT: Hz
--GRID REQ HIGH--
INPUT: 63.0
UNIT: Hz
--ACTIVE Type--
1: PWR- VOLT RES
2: PWR- FREQ RES
3: PFC VOLT RES
4: PFC FREQ RES
5: ACTIVEISLANG
6: Leak Curren
7: Insulation d
V
V