Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Always start the machine when it is completely
assembled.
Observe the enclosed mounting sheet!
Mounting the handle
Plug the upper handle (2a) and the lower handle (2b) onto
the rubber sleeve (A).
Secure both parts with the 4 screws [Torx M5x35],
washers and spring rings].
Mounting the carrying strap
Hook the carrying strap (3) in the suspension eye (B).
Make sure that the snap hook (C) of the carrying strap is
hooked in as shown in the figure.
Assembling / disassembling attachment tools
Pull out the locking pin (D) and push the respective
attachment tool [brush cutter (4), hedge trimmer (12) or
pruner (14/15)] into the drive unit against the stop (1).
Release the locking pin.
Make sure that it engages with a click.
Firmly tighten the clamping screw (E).
Remove the attachment tool in reverse order.
Assembly brush cutter / grass trimmer
Mounting the cutting blade guard
Plug the guard (5) on the seat (F).
Secure it with 3 screws [M5 x 12], washers and spring
rings.
Mounting the cutting blade
Risk of injury!
Wear protective gloves during assembling the
.
cutter blade
First plug the guard (6) on the drive shaft (G), then in
sequence the cutting blade (7), spacer disc (9) and cap
(10). Screw the mounting nut M10 (11) counter clockwise
on the drive shaft.
Now rotate the hole (H) of the guard (6) over the recess in
the seat (F).
Left-hand thread!
Lock the drive shaft (G)
Now tighten the thread head (11) with the mounting tool
(23) fest.
32
Assembly
Mounting the guard extension for the thread head
Lock the drive shaft (G) over the gab of the seat (F).
Left-hand thread!
Now tighten the thread head (12) on the drive shaft (G).
Assembly hedge trimmer
Install the drive unit (1) and the hedge trimmer attachment
(13) as described in the section "Mounting/dismantling the
attachment tools".
Assembly power pruner
Installing the guide bar and the saw chain
Risk of injury!
Wear protective gloves when working on the guide
bar and the saw chain
Place the power pruner on a level surface
Remove the securing nut (17a) and remove the cover
).
(17
Turn the chain stretching screw (31) anticlockwise until
the chain stretching pin (J) is at the rear end of the thread.
Insert the saw chain (21) in the circumferential guiding
groove of the guide bar (20)
the clutch (52) on the chain wheel (30).
Attend to the correct running direction of the
chain links.
Place the guide bar (20).
The chain stretching pin (J) must engage in the provided
chain stretching hole (I) in the guide bar.
When assembling, pay attention that the chain
links are lying correctly within the guide slot
and on the chain wheel (30).
Remount the cover (17) and tighten the securing nut (17a)
hand-tight.
Stretch the saw chain as described in section „Stretching
the saw chain
Assembly power pruner
Plug the shaft section together as needed and described
in the section "Assembly" Mounting/dismantling the attachment
.
tools
Long version: parts 1, 15 and 16
Short version: parts 1 and 16.
Make sure the plug connections lock properly.
.
.
.
Put the saw chain (21) over
Werbung
