Device Description / Spare Parts; Assembly; Commissioning; Adjustments On The Hedge Trimmer - ATIKA HA 500/51 Betriebsanleitung

Description / Spare parts
Pos. Denomination
1/
Knife
2
Knife protection HA 500/51
Knife protection HA 620/55
Knife protection HA 710/61
3
Hand guard (HA 500/51)
Hand guard (HA 620/55, HA 710/61)
4
Safety label
5
Front handhold with switch button
6
Ventilation slots
7
Rear handhold with ON- OFF switch
8
Cable with power plug
9
Cover strip
10
Impact protection
11
Switch for the angular motion of the
rear handhold
Attach the hand guard (3) with screws to the device
prior to startup.

Commissioning

Mains connection
Compare the voltage given on the machine model plate e.g.
230 V with the mains voltage and connect the hedge trimmer to
the relevant and properly earthed plug.
Alternating current motor:
Use a shockproof plug, mains voltage 230 V with
residual current circuit breaker 30 mA and 10 A fuses.
Use connection cable or extension cable respectively with a
cross section of at least 1.5 mm².
Mounting of the extension cable
In order to prevent an unintended loosening of the
connection assembly put the extension cable as noose
through the opening on the rear handhold (7) and put it over
the cable mounting.
Order-No.
364196
364197
364198
364194
364195
364190
364199

Assembly

Switch on
Do not use any device where the switch can not be
switched on and off. Damaged switches must be repaired
or replaced immediately by the customer service.
The hedge shears has a two-hand protective shut-down which
prevents an unintended switching on.
Push the circuit closer/breaker on the rear handhold (7)
and operate at the same time with the other hand the switch
button on the front handhold (5).
Switching off
For switching off the device release the circuit closer/breaker or
the switch button.

Adjustments on the hedge trimmer

Turn handhold (Type HA 620/55; HA 710/61)
The handhold can be set to 5 working positions (45° raster)
During the setting the circuit closer/breaker on the rear
handhold (7) can not be operated.
Hold the hedge shear on the front handhold (5).
Push the switch (11) backwards.
The rear handhold (7) can be turned into the desired
position.
Release the switch (11) and make sure that it engages. The
handhold is fixed.

Working instructions

You may not start to operate the machine until
you have read these operating instructions,
observed all the instructions given and installed
the machine as described!
Observe all safety instructions in any case.
Before commencing work, ensure the following:
Workplace tidied?
You may not start to operate the machine until you have
read these operating instructions, observed all the
instructions given and installed the machine as described!
Always keep the ventilation apertures free.
Scare animals off the hedge before starting to cut in order to
prevent them from being injured.
Best time for hedge trimming:
Leaved hedge:
⇒
Conifer hedge:
⇒
⇒ Quickly growing hedge:
June and October
April and August
from May and then every 6
weeks
19