ATIKA AMGS 40 Originalbetriebsanleitung Seite 31

 Wear safety glasses and hearing protection. Further
protective equipment for head, hands, legs and feet is
recommended. Adequate protective clothing will reduce
personal injury by flying debris or accidental contact with the
saw chain.
 Do not operate a power pruner in a tree. Operation of a
power pruner while up in a tree may result in personal injury.
 Always keep proper footing and operate power pruner
only when standing on fixed, secure and level surface.
Slippery or unstable surfaces such as ladders may cause a
loss of balance or control of the power pruner.
 When cutting a limb that is under tension be alert for
spring back. When the tension in the wood fibres is
released the spring loaded limb may strike the operator
and/or throw the power pruner out of control.
 Use extreme caution when cutting brush and saplings.
The slender material may catch the saw chain and be
whipped toward you or pull you off balance.
 Carry the power pruner by the front handle with the chain
saw switched off and away from your body. When
transporting or storing the power pruner always fit the
guide bar cover. Proper handling of the power pruner will
reduce the likelihood of accidental contact with the moving saw
chain.
 Follow instructions for lubricating, chain tensioning and
changing accessories. Improperly tensioned or lubricated
chain may either break or increase the chance for kickback.
 Keep handles dry, clean and free from oil and grease.
Greasy, oily handles are slippery causing loss of control.
 Cut wood only. Do not use power pruner for purposes
not intended. For example: do not use power pruner for
cutting plastic, masonry or non-wood building materials.
Use of the power pruner for operations different than
intended could result in a hazardous situation.
Description of device / spare parts
Pos. Designation
1 Driven unit
2 Handle complete
2a Handle upper part
2b Handle lower part
3 Carrying strap
4 Attachment - brush cutter
5 Safety guard
6 Safety cover
7 Cutting blade
8 Transport guard for brush cutter
9 Spacer washer
10 Protective cover
11 Fixing nut M10
12 Thread spool
13 Attachment hedge trimmer
14 Transport guard for hedge trimmer
15 Extension shaft – power pruner
16 Attachment – power pruner
17 Cover
17a Nut M10 (for cover)
18 Fuel tank cap
19 Tank (chain oil)
20 Guide bar
21 Saw chain
22 Chain protection
23 Installation wrench
24 Allen key SW 4
25 Screw drewer
26 Open end wrench SW 8/10
27 Charger
28 Battery 2,0 Ah
29 Battery 4,0 Ah
30 Chain wheel
31 Chain stretching screw
32 Trip switch
33 On-/off-switch
34 Speed switch
35 Cutting device
36 Zerk fitting M6
37 Thread knife
38 Protection cap
39 Accessories bag
40 Safety label - pruner
41 Safety label – hedge trimmer
42 Safety label – brush cutter
43 Safety label – protection guard
Order-no.
386105
385805
386215
385941
385855
385856
386119
386120
386122
386217
386114
386163
386164
386160
386219
386218
386151
365500
365501
365503
386174
386216
386184
386203
386202
386201
386200
31