Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Maintenance
Before each maintenance and cleaning work
Switch off device.
Wait until the cutting device does not longer
move.
Remove the battery.
Wear protective gloves during maintenance and
cleaning work in the area of the cutting tool to
avoid possible injuries.
Maintenance and repair work other than those described in this
chapter is only allowed to be carried out by service staff.
For maintaining and cleaning, removed security devices must
unconditionally be mounted properly and proved again.
Only use genuine spare parts. Other than genuine parts may
result in unpredictable damages and injury.
Maintenance - General
To guarantee a long and reliable usage of the product carry out
the following maintenance works regularly.
Check the device for obvious defects such as
loose fastening elements
worn or damaged components
bent, broken or damaged cutting tool
Necessary repair works or maintenance have to be carried
out before using the machine.
A damaged cutting tool must be replaced by a new
one.
The cutting tool will not come to a standstill
immediately after cut-off. Before starting any service
work wait until all parts are stationary.
Lubricate the gear box
Lubricate the gearbox every 25 operating hours
1. Put the grease gun onto the grease filling plug (36)
grease filling plug is located at the gearbox
2. Force some grease into the zerk fitting
Use SHELL ALVANIA RL3, for example, or an equivalent
grease brand.
38
.
.
The
.
.
Maintenance brush cutter / grass trimmer
Cutting blade (7)
Safe and efficient working is only possible with a
correctly sharpened and intact cutting blade.
Therefore, check the cutting blade for dull edges, bents, cracks
or other damages on a regular basis.
Have dull cutting blades sharpened by a specialist/service
workshop.
Both sides of the cutting blade may be used. Turn round
the cutting blade once and continue to work with the brush
cutter until both sides of the cutting blade are dull-edged.
Replace damaged cutting blade by new one.
Replacing the thread spool (12)
Remove dirt and grass residues.
Lock the drive shaft (G) in the holder (G) via the recess.
Left-hand thread!
Unscrew the thread spool (12) (G) and screw a new
thread spool in place.
Sharpening or replacing the thread knife (37)
Do not use unsharpened or damaged thread knives. A
damaged thread knife must be replaced by a new one.
Unscrew the thread knife (37).
Clamp the thread knife into a vice and sharpen it with a flat
file.
Make sure not to change the angle of the knife and file
only in one direction.
File carefully.
Screw down the thread knife again as shown.
Do not over tighten the screws.
Maintenance hedge trimmer
Cutting device (35)
Check the following regularly
the screw joints of the cutting device for firm fastening.
Loose screw joints cause an unsatisfactory cutting result
because the blades can no longer close correctly.
Risk of injury! Loose screw joints may separate during
work resulting in cutting injuries.
the blades for notches. Too many notches make work more
difficult because the blades are dull. These notches will also
damage the wood.
Have the blades sharpened by a specialist.
the cutting device for deformed, broken or damaged blades.
Necessary repair works or maintenances have to be
carried out before using the power tool.
Werbung
