Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Start up - Power Pruner
Saw chain
Before checking/tensioning the saw chain
- switch off the device
- remove the battery
- in order to avoid injuries wear protective
gloves.
Check the saw chain tension
before start of work
after the first steps
during sawing regularly all 10 minutes
Only with a correct clamped saw chain and a
sufficient lubrication you can influence the durability.
Please observe the following:
a new saw chain must be reclamped more often.
in case of heating of chain to operating temperature it
expands and needs to be reclamped.
After finishing the sawing works release tension of saw
chain as in case of cooling too high tensions would emerge
in the saw chain.
if chain flakers or comes out of the guide clamp it again
immediately.
Clamping of saw chain
Loosen the retaining nut (17a) by max. 1 turn.
Slightly lift the guide bar tip and turn the chain stretching
screw (31) clockwisely until the correct chain tension is
reached.
saw chain is correctly stretched when it can be lifted in
The
the centre of the chain guide by appr. 3 – 4 mm.
Turn the chain stretching screw anti-clockwise when the
saw chain is stretched too much.
Check that the chain links are positioned correctly in the
guiding groove of the guide bar.
Re-tighten the locking nut (17a).
Checking the chain lubrication (oil-automatic)
Never operate the power pruner without functioning
chain lubrication.
Check the function of the automatic chain lubrication by
switching on the power pruner and holding it with the spike
in direction of a carton or paper on the ground.
Checking the chain lubrication
Do not get in contact with the ground with the chain. Keep
a safe distance of 20 cm.
If an increasing oil track is caused when checking it the oil
automatic works faultless
If there is no oil track despite full oil tank
Clean the chain clamping boring (I) and the oil flow
channel (K).
If this is not successful please contact the customer
service.
34
Working with the device
You may not start to operate the machine until you
have read these original instructions, observed all
the instructions given and installed the machine as
described!
Observe the "Safety notices" and the following
additional operating notes.
Always keep your hands and feet at a safe distance
to the cutting tool.
Carrying strap
Always apply the carrying strap (3) when
working with this machine.
Never wear the carrying strap diagonally over
shoulder and chest, but only on one shoulder. In
this way, you can quicker remove the machine from
your body if you get in a dangerous situation.
Adjusting the carrying strap
Make sure the carbine (C) of the carrying strap is correctly
assembled and hooked in.
Adjust the carrying strap so that
the carbine is approx. one hand width below the right
hip.
ergonomic and secure carrying of the device is
guaranteed.
Immediately replace a damaged carrying strap.
Quick-acting closure
There is an easily accessible quick acting closure (Q) on
the carrying strap. It ensures that you can quickly remove
the machine from the carrying strap in a dangerous
situation.
To disconnect it jerkily pull on the strap end (L) of the
quick acting closure.
Correct working position
Assume a secure stand, hold the device firmly with both
hands; the left hand always encloses the guide handle and
the right hand the operating handle. This applies also to left-
handed persons!
Position the guide handle to allow you guiding the device
securely and conveniently.
Hold the device during cutting so that
it is at an adequate distance from the body.
Make sure the cutting tool does not lie on the ground when
switching the device on.
Werbung
