Installation Of The Mounting Rails (4 Pieces); Installation Of The Angle Bracket - Sartorius Stedim Biotech CERTOMAT Tplus Bedienungsanleitung

2.3.4.1 Installation of the Mounting Rails (4 pieces)

1. Attach the first mounting rail with the upper screw in
the provided position of the side wall (slightly tighten
the screw).
Care for the correct mounting position (see figure 6)
Figure 6: Mounting position of the mounting rail
2. Insert the remaining 2 screws into the screw holes
and tighten them slightly.
3. Securely tighten all screws.
4. Install the remaining 3 mounting rails in the same
order.

2.3.4.2 Installation of the Angle Bracket

1. First attach the upper hook of the angle bracket in
the recess of the mounting rail at the desired height
(see figure 7).
Figure 7: Installation of the angle bracket
All manuals and user guides at all-guides.com
Mounting rail
Angle bracket
2. Now press the angle bracket in such a way that the
lower end of it snaps in the mounting rail – one recess
notch under it (see figure 8).
Figure 8: Assembled angle bracket
3. Install the remaining 3 angle brackets in the same order
at the other mounting rails.
Take care for the equal height of the angle brackets.
4. Insert the grid for petri dishes into the device.
The air flow of the device ventilator inside must not be
blocked!
Always mount the tray insert below the device ventilator
located on the back of the device.
Make sure that the grid for petri dishes has been securely
mounted in horizontal position.
5. If necessary:
− remove the grid for petri dishes
− remove the incorrectly positioned angle bracket by
pressing it slightly
− install the angle bracket in a new position again
Mounting rail
Angle bracket
9