Configuration Of The Certomat® Tplus And; Optional Equipment; Shaking Drive With Tray Support; Illumination Unit (Option) - Sartorius Stedim Biotech CERTOMAT Tplus Bedienungsanleitung

2.3 Configuration of the CERTOMAT® Tplus and

Optional Equipment

2.3.1 Shaking Drive with Tray Support

•
The shaking drive will be mounted in the factory prior
to delivery in the shaking cabinet and will be ready
for use after assembly of the tray and loading with
shaking containers. Rebuilding to a different orbit
must only be done by authorized and qualified service
personnel. Please contact your service representative
or the service department of Sartorius AG, if
necessary.

2.3.2 Illumination Unit (option)

• Push the illumination unit in the prepared guiding
bars. You have to release the 4 fastening screws of
the pull bars first. Push the illumination unit into the
device until the cross hole in the pull bars becomes
visible. Insert the delivered screws in the cross holes
and protect the illumination unit in this way from
sliding out. Fasten the 4 fastening screws carefully
again. Plug the plug for the mains supply into the
prepared socket in the incubation chamber (refer to
fig. 1). Secure the plug (refer fig. 2) by fastening the
connecting nut in the socket (refer fig. 3). The
illumination unit is than ready for operation.
If required, individual lamps can be manually switched
off to reduce the light intensity (refer fig. 4).
Fig. 1: Socket for the optional illumination unit
Fig.. 2: Plug of the optional lighting unit
8
All manuals and user guides at all-guides.com
Fig. 3: Affiliated illumination unit
Fig. 4: Switch for fluorescent tubes

2.3.3 Connection of the Optional Cooling Devices

• If your CERTOMAT® Tplus includes the optional cooling
unit, no additional connections are required. Any
condensate produced during cooling operation will be
evaporated inside the cabinet and the humid air be
exhausted via the ventilation of the cabinet.

2.3.4 Installation of the Grid for Petri Dishes (optionally)

Scope of delivery:
4
Figure 5: Grid for petri dishes with installation
material
1. Fastening screws
2. Mounting rails
3. Angle bracket
4. Grid for petri dishes
1
2
3
(12 pcs.)
(4 pcs.)
(4 pcs.)
(1 pcs.)