Delivery And Installation; Delivery And Checking Of Completeness - Sartorius Stedim Biotech CERTOMAT Tplus Bedienungsanleitung

2

Delivery and Installation

2.1

Delivery and Checking of Completeness

The configuration and the extent of delivery of the
incubation shaking cabinet depend on the individual
order. The shaking drive, and if ordered, the option
„cooling unit" will be preinstalled in the factory prior
to delivery according to the customer´s demands.
Each CERTOMAT® Tplus is delivered after a thorough
functional test. For transport to the working place,
and prior to installation and start-up of the unit you
should check the following:
1. A suitable transport route through the building and
appropriate transportation means (lifting trucks, etc.)
should be available. The floor, the doors and elevators
must be large enough for safe transport.
2. The working place must be suited for the shaking
cabinet. It must offer sufficient space for convenient
placement and it must compensate the weight of the
completely mounted shaking cabinet:
− Single cabinets or a stack of two cabinets can be
placed on a support frame. This will ease operation
of the controls.
− Dimensions of the support frame:
1150 x 200 x 710 mm (W x H x D)
− Weight of CERTOMAT® Tplus:
approx. 230 kg including load
For devices with integrated cooling unit (UHK versions),
the following applies for incubations below the
ambient temperature:
If the machine is operated continuously for a long
period in conditions of relatively high humidity, ice can
form on the vaporiser.
The formation of ice on the vaporiser reduces the air
circulation.
This can activate the overheating safety cut-out and
switch off the machine.
Allow the machine to cool down before turning it on
again.
• For placement of one or 2 cabinets in stack
arrangement we recommend to place the (lower)
cabinet onto the optional support frame. This makes
the operation easier.
• Up to three cabinets can be stacked. In this case the
working place must be steady enough to carry the
weight of all cabinets including all accessories and the
load. Also the dimensions of the devices must be
taken into consideration.
3. The working place must be able to compensate
vibrations which are caused by the shaking operation.
Make sure that surrounding equipment cannot be
disturbed by the Tplus. Please observe the notes for
the limitation of the shaking speeds in chapter 3.
6
All manuals and user guides at all-guides.com
The action of the loaded trays causes vibrations, which
will change with load and shaking speed. These
vibrations cannot be fully compensated by the adjustable
counter-balance weight. Especially at heavy loads (>10
kg) and high shaking speeds resonance effects may occur
and vibrations may be transmitted to the working place.
4. The power supply of the laboratory must correspond to
the technical specifications of your CERTOMAT ® Tplus
-see the labels on the unit. Compare the existing line
voltage with the data on the nameplate of the device.
5. The shaking cabinet has been designed for normal
laboratory conditions, see information about the
environmental conditions in the supplement. Under
special environmental conditions or when using
aggressive media you have to test the suitability of all
parts. Malfunction and damage, such as corrosion by
aggressive media, are not subject of our guarantee.
If the working place is not suitable for the
CERTOMAT® Tplus and the unit does not correspond with
your power rating, you must not start and operate it.
6. Please check the condition of your device and the
accessories provided. All components specified in the
order are premounted or are enclosed in the delivery.
The delivery should be complete and all parts
undamaged.
•
If the CERTOMAT® Tplus has the wrong mains
specifications, in case of malfunction of the unit or if
any parts are damaged or are missing inform your
Sartorius Stedim Biotech GmbH representative as soon
as possible.