Mounting Of Trays And Mounting Sets; Assembly And Loading Of Finally Equipped Sets; Mounting Of Test Tube Racks - Sartorius Stedim Biotech CERTOMAT Tplus Bedienungsanleitung

2.5

Mounting of Trays and Mounting Sets

2.5.1 Assembly and Loading of Finally Equipped Sets of
Trays
Fig 11: Tray type F with clamps for Erlenmeyer
flasks

2.5.2 Mounting of Test Tube Racks

Fig 12: Test tube rack assembly
All manuals and user guides at all-guides.com
The trays type E and F are available as completely
equipped trays. Detailed information you will find in
the "Ordering Information" in the supplement.
1. Place the tray in the CERTOMAT® Tplus and fasten it as
explained in chapter 2.4.3 Mounting and Dismounting
a Tray.
2. Insert the Erlenmeyer flasks in the clamps (you can
also use bottles, beakers etc. which fit in the clamps).
Please take care of the distribution of the loads and
distribute them evenly starting from the centre of the
tray outward.
Before starting the shaker check the proper fixation of
all containers. They must not get loose and flung off
during operation of the shaker.
1. Loosen the clamping screw of the test tube rack and
turn the test tube holder, until the screw-holes for
attachment of the rack to the tray are accessible. If
necessary, you may completely remove the holder
from the rack.
2. Place the test tube rack onto the universal tray and
tighten with the mounting screws. Consider the
number of racks required for your application and
distribute the racks evenly on the tray starting from
the centre of the tray outward.
3. As far as being disassembled, mount again the test
tube holders to their racks. Turn the holders into their
working position (usually vertical). Locate with their
clamping screw.
4. The test tube holders can be fixed at any angle of use
as required. Make sure that no liquid escapes from the
vessels during operation.
Avoid contact of the vessels with one another (danger
of breakage!).
13