Stopping / Cancelling A Program - Sartorius Stedim Biotech CERTOMAT Tplus Bedienungsanleitung

7.5

Stopping / Cancelling a Program

To stop or cancel a running program,
proceed as follows:
Step
Call up main "Batches"
menu.
Select mode.
Stop program.
Only a program stop/cancellation takes place.
All process values/states active at the time of the program stop/cancellation (temperature, speed, photo illumination and
cooling) remain active.
The shaker continues to run with the values entered before the program stop/cancellation.
Changes are carried out directly in the respective controller for temperature (TEMP) or speed (SHAKER)
or at the photo illumination (ILLUM) or cooling (COOL) switch.
• Carry out change of temperature or speed by pressing the "TEMP" or "SHAKER" key.
− Enter new value and confirm with "ok" or set controller mode to "off" and with confirm "ok".
• Make changes to the photo illumination or cooling by pressing the "ILLUM" or "COOL" key.
− Switch photo illumination or cooling off or on by pressing the "Off" or "On" key.
All manuals and user guides at all-guides.com
Key, Symbol, Display Input
Press the "Batches" key.
Press the "Mode" key.
Press the "Stop" key.
37