Mounting Of The Universal Mounting System - Sartorius Stedim Biotech CERTOMAT Tplus Bedienungsanleitung

2.5.3 Mounting of the Universal Mounting System

The universal mounting set is available for the trays of
size EU and FU. Enclosed you will find further
information about the component parts. Basic parts
are two side frames which are adapted to the
corresponding tray and the rods for connection of the
side frames:
• Set of side parts type B-2, art. no. 8854238, for tray
EU
•
Set of side parts type B-3, art. no. 8854243, for tray FU
Universal clamping rods and mounting sets for
separation funnels serve as mounting systems
•
Universal clamping rods type U, art.-no. 8854254, for
side part set B-2 / B-3
• Mounting set type S-1 for separating funnels 50 and
100 ml, art. no. 8854262, with clamps and retaining
springs and 1 universal clamping rod type U
• Mounting set type S-1 for separating funnels 250, 500
and 1000 ml, art. no. 8854270, with clamps and
retaining springs and 1 universal clamping rod type U
Fig. 13: Assembly of universal rods and mounting
sets for separating funnels
14
All manuals and user guides at all-guides.com
1. Place the side parts (1) onto the tray and screw them
onto the tray with the mounting screws as shown at
pos. (1a). For each side part 4 screws are supplied to
provide proper tightening. Then mount connecting
rods as shown at pos. (1b).
2. For a mounting system with universal clamping rods
attach the clamping rods at the side frame rods as
shown at pos. 3. You'll need at least two rods and you
can add as many as required for placement of your
vessels.
3. Place the shaking containers between the clamping
rods. Distribute the containers evenly on the tray,
starting from the centre outward. You can loosen the
clamping screws 3a/3b of the rods to readjust the rod
and properly position the flasks, vessels and beakers,
etc. Then carefully tighten the clamping screws (3a/3b)
so that the containers do not loosen during operation.
4. For the mounting set for separation funnels attach
one universal clamping rod as shown above. It will
serve as support. Then mount the retaining springs (2a)
to the clamping rod for separation funnels (2).
Depending on the size of the separation funnels you
can mount up to 5 retaining springs to the clamping
rod (pos. 2a).
5. Place the separation funnels onto the mounting set.
You can readjust the clamping rods as required using
their clamping screws attached.