Kenwood KAX92.AOME Bedienungsanleitungen Seite 4

Key
KAX92.AOME
Hopper
1
Feed tube
2
Body
3
Scroll
4
Die*
5
Securing nut
6
Clamp ring of cutting
7
assembly
Cutting blade
8
Spanner/pusher
9
Cleaning tool
10
*Included in your pack is the
Maccheroni Rigati die shown
on the illustration page. To
purchase any of the additional
dies shown on the back page
of this booklet, please visit
www.kenwoodworld.com.
To Assemble Your
Attachment
Refer to illustrations
Optional: for easier pasta
making, warm the body, die and
ring nut in hot water, then dry.
A
Fit the scroll inside the body.
B
Fit the die.
C
Fit the securing nut and
hand tighten. (Do not use
the spanner/pusher as this is
to assist with removal only).
Make sure the securing nut
is almost flush against the
body of the attachment.
D
Lift off the slow speed outlet
cover.
E
With the attachment in
position shown, locate to the
slow speed outlet and rotate
to lock in place.
F
Fit the hopper.
Cutting Assembly
Optional: The cutting assembly
assembled pasta shaper to assist
with cutting the pasta into the
desired lengths.
A G
–
To Use Your Pasta
shaper
Refer to illustrations
4
and can be fitted to the
7 8
G
With the handle of the
cutting blade uppermost,
unscrew the clamp ring
slightly. Place over the
securing nut and twist if
necessary until fully home
on the attachment. The die
should fit flush with the front
of the cutting assembly.
Hold the edge of the cutting
assembly and at the same
time tighten the clamp ring
by turning away from you.
Note: Whenever you fit
or remove the cutting
assembly, always hold the
edge of the assembly in one
hand and twist the clamp
ring with the other.
Use speeds 2-3 to process
your pasta.
Make your pasta mix
following a recipe supplied.
Do not make the mix too
dry as it could break your
pasta shaper or machine.
It should resemble coarse
breadcrumbs or a coarse
crumble texture. The
particles should be separate
but if squeezed together it
should form a clump which
bonds together.
H
Switch the machine onto
speed 2-3.
Place some of the mix onto
the hopper. Feed a small
amount of mix into the
feed tube at a time. Allow
the scroll to clear before
continuing. If the feed tube
becomes clogged use the
H I
–