Troubleshooting - Stryker Crossfire Bedienungsanleitung

Troubleshooting

Problem
Console A hardware fault is
detected
The AC voltage is
incorrect
A software default
is detected
The system does
not power on
The electrical
interference is
sporadic
The generator
temperature is too
high
A power-on self
test error has
occurred
Hand- The temperature is
higher than normal
piece
The unit has
reached its
recommended
service interval
Possible Solution
• Turn the power off and on again.
• If the problem persists, contact a
Stryker representative or return the
console for repair.
• Turn the power off and on again.
• If the problem persists, contact a
Stryker representative or return the
console for repair.
• Turn the power off and on again.
• If the problem persists, contact a
Stryker representative or return the
console for repair.
• Check the power cord to ensure it
is properly connected.
• Check to ensure the cord is
connected to a grounded outlet.
• Power down all electrical
equipment not in use.
• Increase distance of other electrical
equipment.
• Connect the unit and other
equipment into different outlets.
Ensure that there is proper airflow
around the unit.
• Turn the power off and on again.
• If the problem persists, contact a
Stryker representative or return the
console for repair.
Allow the unit to cool before
restarting.
Contact your Stryker
representative.
EN-33