Herunterladen Inhalt Inhalt Diese Seite drucken

Set Foot Pedal Function; Boost Touch-Pad; Chime Volume Adjustment - COOK Medical K-MAR-5200 Handbuch

Vorschau ausblenden Andere Handbücher für K-MAR-5200:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 57
K-MAR-5200 Instructions for Use
IMPORTANT NOTE: This
keystroke must be entered correctly to
change the Foot Pedal Function.
1
If the Vacuum display does not indicate
Latching or Non-Latching Mode, retry
the sequence.
IMPORTANT NOTE: The boost
vacuum may not reach -500mmHg
when testing with large gauge needle
sets due to lower flow resistance.

3.13.3 Set Foot Pedal Function

To change the setting.
1.
Ensure that the Vacuum Pump is in standby mode by using the Standby Touch-Pad.
2.
Press the following sequence of Touch-Pads on the front panel to enter set Foot Pedal Function mode where
Adjust Vacuum Touch-Pads are
,
The Vacuum Display should now show either:
Indicates Latching Mode
Indicates Non-Latching Mode
If neither of these are displayed, repeat steps 1 & 2.
3.
Press
Adjust Vacuum Touch-Pad Decrease to toggle between Latching and Non-Latching mode.
4.
Switch the device into active mode using the Standby Touch-Pad to exit the procedure.
5.
To test that the Foot Pedal Function has been set, depress the Foot Pedal and the device should behave
accordingly.

3.14 Boost Touch-Pad

With a Disposable Vacuum Line with Hydrophobic Filter (K-DVLF-240), test tube, and needle set attached:
• Activate the Foot Pedal.
• The Vacuum Supplied Indicator lights up.
• Press and hold the Boost Touch-Pad
• The device will reach a maximum vacuum of -500 mmHg (-67.0 kPa). A small overshoot may occur up to -530 mmHg
• Release the Boost Touch-Pad
• The Vacuum Display should reach the pre-selected value within ±5 mmHg.

3.15 Chime Volume Adjustment

1.
Ensure that the Vacuum Pump is in standby mode by using the Standby Touch-Pad.
2.
The Boost Touch-Pad
can now be used to adjust the volume.
3.
Each touch of the Boost Touch-Pad adjusts the volume in a sequence of 4 steps from minimum volume to
maximum volume.
The steps are displayed on the Vacuum Display with each touch of the Boost Touch-Pad.
No Volume
Minimum Volume
Medium Volume
Maximum Volume
4.
You can now set the volume to suit your preference.
1-9
and Boost Touch-Pad is
.
, the Boost Indicator lights up.
English

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis