Replacing Static Lithopatterns; Figure 5-14 Replacing Static Lithopatterns - High End Systems x.Spot Xtreme Handbuch

Replacing Static Lithopatterns

Positions 3 and 7 on Gobo Wheel 1 in the Dual Rotating Gobo Module contain slots
for the addition of static lithopatterns, (see Figure 5-14).
To replace a static litho:
1. Use the directions from the preceding section to remove the rotating litho in front
of the static litho.
2. Gently spread the static litho framing bracket away from the wheel and slide the
static lithopattern out of the frame (see Figure 5-14).
3. Choose the orientation of the selected lithopattern. To product a moiré effect
place the coated side of the top litho facing toward the bottom litho. For morphing
effects, place the coated side of the top litho facing away from the lamp.
4. Slide the new lithopattern into the frame. Make sure the static litho is seated.
5. After replacing the litho, clean it by using a soft, lint-free cotton cloth and a mild
glass cleaning solution (containing no ammonia).
6. Replace the bezel, (see Figure 5-1 on page 5-1).
5-14 General Maintenance
®

Figure 5-14 Replacing Static lithopatterns.

Static lithopattern positions
Static lithopattern framing bracket
x.Spot Xtreme User Manual
®