Inhaltsverzeichnis
Werbung
5. Referring to Figure 5-12, use a 2.5mm allen wrench to remove the 3 socket cap
screws (A) holding the hub (B) and the spring retaining clip (C) to the wheel.
Figure 5-12 Accessing Dichroic wedges in Static Color Wheel.
A
D
6. Lift the retaining clip to access all the color wedges. Lift out and replace selected
wedges.
Note: The tabbed wedge (D) must always remain in the position directly opposite
the open position. When ordering color wedges be sure to specify whether it
should be a tabbed or a standard shaped wedge.
7. Align the retaining ring over the wedges. Replace socket cap screws. Tighten
after all three screws are in place.
8. Replace the wheel in the fixture and tighten the set screw to secure it to the hub.
9. Reattach the bezel guiding it into the bezel channel on each yoke and retighten
captive bezel screws, (see Figure 5-1).
Replacing Lithopatterns
This section explains how to remove and replace individual components in the
rotating gobo wheels for x.SpotXtreme fixtures. These directions apply to any gobo,
lithopattern, or effect glass in x.SpotXtreme fixtures that adheres to the
specifications listed in the section titled "Dichroic, Litho, and Effect Specifications"
on page 1-6.
Replace lithopatterns or effects if they are damaged or broken, to change their order
in the wheel, to clean them, or to install a new or custom lithopattern or effect. (See
"Optional Accessories" on page 1-4 for ordering information.)
If applicable, remove all pieces of broken glass in the fixture before beginning.
Warnings: Disconnect power before servicing.
Equipment surfaces may reach temperatures up to 130° C (266° F).
Allow the fixture to cool before handling.
5-12
General Maintenance
C
B
and Effects Glass
®
x.Spot
Xtreme User Manual
®
Werbung
Inhaltsverzeichnis
