Inhaltsverzeichnis
Werbung
Mounting the Fixture
Mount the x.SpotXtreme fixture either upright (on the fixture's base), in any
orientation suspended from a support system (such as a truss) or permanently to a
wall or ceiling.
Warnings:Equipment suitable for dry locations only. Do not expose this
equipment to rain or moisture.
Maintain a minimum distance of 1 m (3.28 ft.) from combustible
materials.
2
Maintain a minimum distance of 2 m (6.56 ft.) from illuminated
object.
Do not mount on a flammable surface.
Use a secondary safety cable when mounting this fixture.
Mounting the Fixture Upright
Caution: Do not mount the fixture upright without the four rubber feet.
To mount the fixture upright, make sure that all four rubber feet are installed on the
fixture's base and place the fixture on a sturdy, stable surface that will support more
than the 32kg (70lbs) weight of the x.SpotXtreme fixture. If the surface is above floor
height, use safety cables to secure the fixture to the surface .
Truss Mounting
When mounting the fixture
on a truss or another type
of support, verify the truss
or support will handle the
combined weight of all the
devices on the truss.
The x.SpotXtreme fixture
has two available mounting
brackets. The standard
mounting bracket
maximizes handle comfort
while allowing diagonal single-pole truss mounting. Optional Center-hole mounting
brackets allow for traditional single pole mounting, see "Optional Accessories" on
page 1-4.
Both mounting bracket styles install on the fixture in the same way. Handles
and mounting brackets can also be removed entirely to accommodate unique
installations, see Figure 2-2.
x.Spot
Xtreme User Manual
®
Figure 2-2 Removing handles and side wings
A
B
To remove side wings:
Remove 2 screws from
each handle (A) and
detach
Remove screw from the
bottom of each rubber
foot (B)
Setup and Configuration
2
2-3
Werbung
Inhaltsverzeichnis
