Inhaltsverzeichnis
Werbung
Replacing the Lamp
Warnings: Disconnect power before re-lamping or servicing.
An operating, unshielded MSR lamp emits ultraviolet and visible
(UV-vis) radiation which could damage eyes and skin. Whenever
working on or near an exposed lamp, wear protective eye gear.
Never look directly at the lamp while the lamp is on.
Hot lamp may be an explosion hazard. Do not open for five
minutes after switching off. Wear eye and hand protection when
re-lamping.
Equipment surfaces may reach temperatures up to 130° C (266° F).
Allow the fixture to cool before handling.
Caution:
This equipment is designed for use with a Philips® MSR 700SA
700Watt, metal halide lamp only. Use of any other type lamp may
be hazardous and may void the warranty.
To install/replace the lamp:
1. Disconnect power to the fixture. If the fixture has been operating, wait for the
lamp to cool before handling.
2. Put on protective eyewear and gloves.
Refer to Figure 5-3 for Steps 3–8.
3. Using a wide tip, flat head screwdriver, loosen (but do not remove) the two lamp
assembly screws (A).
4. Pull the lamp assembly straight out of the fixture (B).
The lamp assembly is connected to the fixture by lamp socket wires (C). Support
the lamp assembly while replacing the lamp. Do not allow the lamp socket wires
to support the weight of the lamp assembly.
5. Holding the existing lamp by its ceramic base, carefully pull the lamp straight out
of the lamp socket (D).
5-4
General Maintenance
Figure 5-3 Replacing the lamp
A
.
Remove lamp
assembly.
B
C
Remove lamp from
lamp socket.
x.Spot
D
Xtreme User Manual
®
Werbung
Inhaltsverzeichnis
