Inhaltsverzeichnis
Werbung
Replacing a Rotating Gobo and Iris Module in Slot 3
Refer to Figure 5-7 for Steps 1–4 in this section.
1. Remove the bezel as shown in Figure 5-1 on page 5-1, and, with the lens pointed
up, rotate the fixture so the tilt belt (A) is on your left. Locate the Rotating Gobo
and Iris Module in Slot 3 (closest to the lens) and gently push the module toward
the lens until the linear slide (B) reaches its limit.
2. Detach the IDC connector (C) from the driver board.
3. Loosen the two captive screws (D) on the module and pull it straight out of the
unit.
4. Slide the new module into the unit, positioning the Gobo wheel between the Dual
Gobos in Slot 2 on the opposite side of the fixture. Use the aligning pins (E) and
bottom (toward lamp) channel guides (F) to orient it properly
A
5. Tighten the captive screws and reattach the IDC connector.
6. Reattach the bezel guiding it into the bezel channel on each yoke arm and
retighten captive bezel screws as shown in Figure 5-1 on page 5-1.
7. Place the old module in the new unit's anti-static bag for return. Include the
Return Material Authorization number (RMA#) obtained from your dealer or
point of purchase along with a written explanation of the problem or malfunction.
5-8
General Maintenance
Figure 5-7 Installing/Replacing Slot 3 Module.
B
E
F
C
D
x.Spot
Xtreme User Manual
®
Werbung
Inhaltsverzeichnis
