Inhaltsverzeichnis
Werbung
Safety Cable
High End Systems strongly recommends using safety cables when mounting any
fixture. Verify the cable used is capable of supporting the weight of the fixture.
Galvanized safety cables can be ordered from your High End Systems dealer/
distributor (see "Optional Accessories" on page 1-4).
Fixture Clamps
Verify that fixture clamps used are capable of supporting the weight of the fixture.
Deluxe C-clamps for a two-inch truss are available from your High End Systems
dealer/distributor (see "Optional Accessories" on page 1-4).
Suggested Truss Mounting Procedure
Note: Due to the wide variety of possible lighting designs, High End Systems
cannot make specific mounting recommendations. Consider the following
procedure as a suggested guideline only.
You will need:
•
safety cables (2)
•
clamps (3 or 4)
•
locking washers (3 or 4)
1. Disconnect power to the fixture. If it has been operating, allow the fixture to cool
for five minutes before handling.
2. At least 2 people are required to mount the x.SpotXtreme fixture with one person
on each side supporting and attaching that side of the fixture. Once the clamps
are attached, one person can support the fixture while the other attaches safety
cables.
Always stand on a firm, stable surface when mounting a fixture to its support.
The fixture should be at a comfortable working height, and should either be
resting on a stable surface, or held in a stable manner. Do not allow one person to
both support and mount the fixture.
3. Attach suitable clamps through the holes on the base of the fixture. Use locking
washers when attaching the clamps to the fixture's base.
4. Tighten the clamps firmly to the fixture's base and to the support.
5. Loop one or more suitable safety cables around the support, around the fixture's
base, and through the fixture's handles.
x.Spot
Xtreme User Manual
®
Setup and Configuration
2
2-5
Werbung
Inhaltsverzeichnis
