Inhaltsverzeichnis
Werbung
Test Options Menu
The TEST OPTIONS MENU manually homes the fixture, turns the lamp on or off,
performs fixture self tests, and stores new boot code information. Performing fixture
self tests may help identify mechanical problems in the fixture.
Note: To see the effects of the self tests, the lamp must be on. If the lamp is off when a
self test runs, the display shows STRIKE LAMP to indicate that the lamp is not
struck, and the fixture will attempt to strike the lamp automatically.
Homing the Fixture
The x.SpotXtreme fixture automatically homes all its functions whenever it is turned
on. This menu option manually homes the entire fixture or any of the following
functional groups individually:
COLOR
To remotely home the fixture using a DMX controller, see "Control" on page 3-9 and
the Channel 14 section of the DMX Table on page A-4.
To manually home the fixture:
1.
Press the Menu button to unlock the menu system or to move back up the system
to the top level menus.
2. Use the left and right arrows on the Navigation button to scroll to the
TEST OPTIONS MENU and press the Enter button to select.
3. Use the left and right arrows on the Navigation button to scroll to HOME FIXTURE.
4. Use the up and down arrows on the Navigation button to scroll through the
homing options available from all to selected function homing options. Press the
Enter button to select.
Lamp State
The LAMP STATE option in the TEST OPTIONS menu turns the lamp ON or OFF.
Copying the Boot Code
When new software is uploaded to x.SpotXtreme fixtures, it may contain a new boot
code which must be copied to each fixture. This is apparent if the fixture displays a
BOOTDIFF error.
Caution: Do not remove power from the fixture while performing a boot copy.
To accept and store the new boot code:
1.
Press the Menu button to unlock the menu system or to move back up the system
to the top level menus.
x.Spot
Xtreme User Manual
®
GOBO
BEAM
PAN/TILT
DIMMING
Fixture Operation
3
ALL
3-23
Werbung
Inhaltsverzeichnis
