Inhaltsverzeichnis
Werbung
Set Parameters Menu
The Set Parameters menu sets all factory options to their default settings or changes
the factory options individually. These factory options are set for the User A or
User B bank of settings individually. To change User Mode, see "Select User Mode"
on page 3-20.
Factory Default Settings
A standard configuration x.SpotXtreme fixture ships with the following factory
default settings:
Preset Playback=OFF
Pan Tilt Swap=DISABLED
Pan Invert=DISABLED
If any of the default settings are changed, this menu reverts to the OFF option. The ON
option restores all factory defaults.
To check and reset factory defaults:
1.
Press the Menu button to unlock the menu system or to move back up the system
to the top level menus.
2. Using the left and right arrows on the Navigation button, scroll through the top
level to SET PARAMETERS MENU and press the Enter button to select.
3. Using the left and right arrows on the Navigation button, scroll to FACTORY
DEFAULT SETTINGS. The current state (ON or OFF) will be displayed.
4. To reinstate the factory defaults if OFF is displayed, use the up and down arrows
on the Navigation button to scroll to ON and press the Enter button to select.
Pan/Tilt Swap
This option swaps the pan motor and tilt motor operation
to coordinate movements between fixtures on a link
mounted perpendicular to each other.
To swap Pan and Tilt:
1.
Press the Menu button to unlock the menu system or
to move back up the system to the top level menus.
2. Using the left and right arrows on the Navigation
button, scroll through the top level to SET
PARAMETERS MENU and press the Enter button to select.
3. Using the left and right arrows on the Navigation button, scroll to PAN/TILT
SWAP. The current state (ENABLED or DISABLED) will be displayed.
3-16 Fixture Operation
Tilt Invert=DISABLED
Display Invert=AUTO
Display Level=ON
Lamp Life Limit=DISABLED
Data Loss Timeout=SHORT
Protocol=STANDARD
x.Spot
Xtreme User Manual
®
Werbung
Inhaltsverzeichnis
