Inhaltsverzeichnis
Werbung
Display Error Messages
8 Character
16 Character Error
Error Message
Message
FOCUS 1 HOMING
EDGEFCS1
EDGE NOT FOUND
FOCUS 2
EDGEFCS2
HOMING EDGE
NOT FOUND
ZOOM HOMING
OPENZOOM
OPEN NOT FOUND
ZOOM HOMING
CLOSZOOM
CLOSING NOT
FOUND
Location
Focus/Frost/Zoom module 2
phase board, motor M3
Focus/Frost/Zoom module 2
phase board, motor M4
Focus/Frost/Zoom module 2
phase board, sensor S2 and M2
Focus/Frost/Zoom module 2
phase board, motor M2
Problem/Procedure
For replacement parts, see "Contacting High End Systems®" on page ii
Focus not homing correctly:
1. Focus homing tab not installed.
2. Check focus wire connection at motor and board.
3. Verify board functioning by substituting with another 2-phase board
from the fixture, see "Replacing a Driver Board" on page 5-6.
4. Check that focus sensor is installed and functioning.
5. Check focus sensors S1 & S4 connection at sensor and board.
6. Check for focus wire harness damaged.
7. Replace motor.
Zoom not homing correctly:
1. Check Zoom sensor connections at sensor and board.
2. Check Zoom motor wire connections at motor and board.
3. Check for wire damage.
4. Verify board functioning by substituting with another 2-phase board
from the fixture, see "Replacing a Driver Board" on page 5-6.
5. Check that Zoom sensor is installed and operating.
6. Check that sensor wheel is installed.
7. Check that pinion gear set screw is tight.
8. Check that Zoom belt is installed and undamaged.
9. Check for Zoom lens damage.
10.Replace motor.
Werbung
Inhaltsverzeichnis
