Herunterladen Inhalt Inhalt Diese Seite drucken

Replacing Modules; Before Beginning; Figure 5-6 Replacing A 2-Phase Driver Board - High End Systems x.Spot Xtreme Handbuch

Inhaltsverzeichnis

Werbung

Caution: The fixture will not function correctly if contact screws are missing
from driver boards.
When changing a board, align the screw holes and standoffs to ensure correct
orientation in the fixture.
To replace a 2-phase driver board:
1. Remove the bezel as show in Figure 5-1 on page 5-1.
2. Use a 3 mm allen wrench to remove the addressing screws and star washers.
3. Position new board against module aligning the center top standoff. Place
contact screw(s) in the appropriate position. Figure 5-6 shows the example for
the Rotation Gobo and Iris Module.
Note: When installing a replacement driver board on a module, always place a
star washer between an address screw and the pad on the logic board to
ensure good electrical contact.
4. Reattach the bezel, guiding it into the bezel channel on each yoke arm and
retighten captive bezel screws (see Figure 5-1 on page 5-1)

Figure 5-6 Replacing a 2-phase driver board.

Addressing screw(s)
Star washer(s)

Replacing Modules

This section describes the steps for installing/replacing the modules available for a
Standard configuration x.SpotXtreme fixture.

Before Beginning

Please note the following warnings and cautions before performing the
procedure outlined in this Installation Instruction.
Warnings: Disconnect power before servicing.
Equipment surfaces may reach temperatures up to 130° C (266° F).
Allow the fixture to cool before handling.
x.Spot
Xtreme User Manual
®
Rotating Gobo and Iris (Slot 3)
Standoffs
General Maintenance
5
5-7

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis