Display Error Messages - High End Systems x.Spot Xtreme Handbuch

Display Error Messages

8 Character 16 Character Error
Error Message Message
PAN HOMING
PANSLOT
SLOT NOT FOUND
TILT ENCODER
TILTENCD
TIMEOUT
EDGEDIM1
DIM 1 HOMING
OPEN NOT FOUND
OPENDIM1
EDGEDIM2
DIM 2 HOMING
OPEN NOT FOUND
OPENDIM2
Location
Top box 3-phase board
Head 3-phase board
Upper dim flag on side opposite
Tilt board.
Lower dim flag on side with Tilt
board.
Problem/Procedure
For replacement parts, see "Contacting High End Systems®" on page ii
Pan or Tilt is not homing correctly:
1. Check that there are no obstructions keeping the unit from correcting
position.
2. Check wiring connections.
– Sensor wire at sensor and board HD6.
– Motor wire at motor and board M1.
– Encoder wire at encoder and board HD7.
3. Replace with another 3-phase board to check for board malfunction,
see "Replacing a Driver Board" on page 5-6.
4. Check that the Sensor is installed and undamaged.
5. Check for sensor wire damage.
6. Check for a broken belt.
7. Check for wire harness or encoder damage.
8. Replace motor.
Dim flags are not homing correctly:
1. Check for obstruction to dim flag movement.
2. Verify color mix board operation by switching with another
2-phase board from the fixture, see "Replacing a Driver Board" on
page 5-6.
3. Check Dim flag motor wire connection at motor and M1 on Color Mix
board.
4. Check Dim sensor S1 connection at sensor and board.
5. Check that Dim flag sensor is installed, undamaged and operating.
6. Check that Dim flag set screw is tight.
7. Check for wire harness damage.