Inhaltsverzeichnis
Werbung
Frost
The Frost parameter settings add a haze or fog effect in increasing/decreasing
densities to the projected pattern. The Frost effect is achieved with two frost flags
that mechanically open and close in the optical path. DMX Channel 8 controls the
Frost parameter with the settings shown in Table 4-3.
Table 4-3 Frost Setting Descriptions
Frost Setting
Open (No Frost)
Variable Frost
Full Frost
Periodic Frost Strobe
Random Frost Strobe
Ramp Open/Snap Shut
Snap Open/Ramp Shut
Ramp Open/Ramp Shut Ramps the frost flags open and then shut at variable speeds
Random Ramp/Snap
Random Snap/Ramp
Focus Control and Focus
Focus Control (Channel 9) sets the Focus to manual focus or the ZoomTrack™ lens
system. With the ZoomTrack lens system on, the image automatically maintains
focus as the zoom changes. Varying the Focus parameter while ZoomTrack lens
system is activated will establish a new focus set point.
The variable Focus parameter (Channel 10) moves elements inside the fixture to
focus on a close image (DMX value of 0) or on an image farther away (DMX value of
255).
Note: Adjusting the focus on x.SpotXtreme fixtures to focus on the iris, a gobo wheel
or the effects wheel creates different patterns and/or effects.
Zoom
Channel 11 controls the Zoom parameter. The Zoom values range from 11° at a
DMX value of 0 to 45° at a DMX value of 255.
4-8
DMX Programming
Removes the frost flags from the optical path
Allows variable diffusion from full open to closed
Frost flags fully closed in optical path
Allows variable strobing of the frost flags from slow to fast
Randomly strobes the frost flags from slow to fast
Ramps the frost flags open at variable speeds and snaps them shut at
full speed
Opens the frost flags at full speed and then ramps them shut at variable
speeds
Ramps the frost flags open at random speeds and then snaps them
shut at full speed
Opens the frost flags at full speed and then ramps them shut at random
speeds
Description
x.Spot
Xtreme User Manual
®
Werbung
Inhaltsverzeichnis
