Onboard Presets Menu; Playback Mode Menu; Edit Scene ## Menu - High End Systems x.Spot Xtreme Handbuch

Onboard Presets Menu

The Presets menu provides many of the features of a DMX controller onboard the
fixture. Presets give the user the capability of programming fixtures for stand-alone
operation by creating, storing, sequencing, synchronizing and playing back scenes.
Onboard Presets also allows to viewing, programming and copying parameters
between scenes on a single fixture or sending them to other fixtures.
For more information on DMX programming at the fixture level including looping
scenes and synchronizing playback, see "Show Creation with Onboard Preset Menu"
on page 4-2.

Playback Mode Menu

This level 2 menu option turns preset playback off or on and displays the currently
programmed sequence of scenes. Set the user mode to A or B through the FIXTURE
MODE MENU, to access this menu option for that user mode. For more information, see
"Select User Mode" on page 3-20.
When PLAYBACK MODE is ON, the fixture plays the currently programmed sequence
up to 16 scenes in length (the maximum for each user mode) or until it reaches a
zeroed scene which indicates the end of a sequence.
The fixture ships with a factory programmed preset sequence that is the initial
sequence for the PLAYBACK MODE. As scene values are edited, the default sequence is
revised to include the new values for that scene.
To Playback a scene:
1. Press the Menu button to unlock the menu system or to move back up the system
to the top level menus.
2. Using the left and right arrows on the Navigation button, scroll through the top
level to ONBOARD PRESETS MENU and press the Enter button to select.
3. Using the left and right arrows on the Navigation button, scroll to PLAYBACK
MODE MENU. The current state (ON or OFF) will be displayed.
4. If OFF is displayed, use the up and down arrows on the Navigation button to
scroll to ON. The fixture will begin playing the currently programmed sequence
and press the Enter button to select.

Edit Scene ## Menu

The EDIT SCENE ## menu gives direct control at the fixture level over the same
parameters as a DMX controller. Edit parameter DMX values of factory preset
scenes to create new scenes, add timing to scenes, zero (erase) the programming for
a scene or end a loop in this menu. After setting the user mode to A or B through the
3-8 Fixture Operation x.Spot Xtreme User Manual
®