Figure 3-4 Assigning Timing To A Scene - High End Systems x.Spot Xtreme Handbuch

Scene 1 Delay time
Scene 1
Note: If the X-FADETIME is longer than the DELAY time for a scene, the fixture
will not reach that scene's values before it begins to play the next scene.
To set TIMING for a scene:
1. Press the Menu button to unlock the menu system or to move back up the system
to the top level menus.
2. Using the left and right arrows on the Navigation button, scroll through the top
level to ONBOARD PRESETS MENU and press the Enter button to select.
3. Using the left and right arrows on the Navigation button, scroll to EDIT SCENE##
and press the Enter button to select.
4. Using the left and right arrows on the Navigation button, scroll to TIMING and
press the Enter button to select.
5. Using the left and right arrows on the Navigation button, scroll to TIMEBASE,
and press the Enter button to select.
6. Use the up and down arrows to scroll to HOURS, MINUTES, or SECONDS, and press
the Enter button to select the unit of measure desired.
7. Press the Menu button to move back to TIMING and press the Enter button to
select.
8. Using the left and right arrows on the Navigation button, scroll to X-FADE TIME.
9. Use the up and down arrows to scroll to a setting from 0.1 to 165 and press the
Enter button to select the X-FADE TIME.
10. Press the Menu button to move back to TIMING and press the Enter button to
select.
11. Using the left and right arrows on the Navigation button, scroll to DELAY TIME.
12. Use the up and down arrows to scroll to a setting from 0.1 to 165 and press the
Enter button to select the DELAY TIME.
3-12 Fixture Operation

Figure 3-4 Assigning timing to a scene

Scene 1
X-fade time
Playing time for Scene 2 values
Scene 2 Delay time
Scene 2
x.Spot Xtreme User Manual
®