Adding Timing To A Scene - High End Systems x.Spot Xtreme Handbuch

16. Use the up and down arrows to set STATIC COLOR value to BLINK COLOR 2/3,
and press the enter button to select. This center's the beam halfway between
Static Color Position 2 (Red) and Position 3 (Yellow).
To edit Slot 2 parameters:
17. Press the Menu button to return to Level 3 Menus. Use the left and right arrows
on the Navigation button, to scroll to SLOT 2 and press the Enter button to
select.
18. Use the left and right arrows on the Navigation button to scroll to
EFFECT POSITION.
19. Use the up and down arrows to scroll to set the EFFECT POSITION value to
POSITION 8, and press the enter button to select the psycho tunnel effect.
20. Use the left and right arrows on the Navigation button to scroll to
EFFECT ROT FUNC.
21. Use the up and down arrows to scroll to set EFFECT ROT FUNC to FWD SPIN, and
press the enter button to rotate the tunnel aperture.
22. Use the left and right arrows on the Navigation button to scroll to
EFFECT ROTATE and press the enter button to select.
23. Use the left and right arrows to scroll to FORWARD ###
24. Use the up and down arrows to set the aperture's forward rotation speed to 100%
of maximum and press the Enter button to select.
To edit Slot 3 parameters:
25. Press the Menu button to return to Level 3 Menus. Use the left and right arrows
on the Navigation button to scroll to SLOT 3 and press the Enter button to
select.
26. Use the left and right arrows to scroll to IRIS and press the Enter button to
select.
27. Use the left and right arrows to scroll to RAMP/RAMP, then use the up and down
arrows to scroll to a value of 5 and press the Enter button to select. This causes
the iris to open and close at the same speed.

Adding Timing to a Scene

The EDIT SCENE menu's TIMING option sets crossfade and delay times for a scene
and specifies the timebase for selected timing. X-FADE TIME is the time a fixture
takes to transition (crossfade) from the DMX parameter values of one scene to the
next. DELAY is the total time the fixture plays a scene before moving to the next scene
and includes any X-FADE TIME at the beginning of the scene. TIMEBASE sets the units
for timing in seconds, minutes or hours. Figure 3-4 describes the timing between 2
scenes.
x.Spot Xtreme User Manual
®
Fixture Operation 3-11
3