Replacing A Six-Wheel Color Mix Module For Slot 1; Figure 5-9 Removing/Installing Slot 3 Module - High End Systems x.Spot Xtreme Handbuch

Replacing a Six-Wheel Color Mix Module for Slot 1

To replace a Six-Wheel Color Mix Module:
1. Remove the bezel as shown in Figure 5-1 on page 5-1.
2. Remove the modules in Slots 3 and 2 (see "Replacing a Rotating Gobo and Iris
Module in Slot 3" on page 5-8 and "Replacing a Dual Rotating Gobo Module in
Slot 2" on page 5-9)
Refer to Figure 5-9 for Steps 3–7 in this section.
Locate the Six-Wheel Color Mix Module that extends through the fixture in Slot 1(at
the base of the unit) and detach the IDC connector (A) from the driver board on each
side of the Color Mix module.
Position the fixture to the side with a bracket holding the module to the fixture frame.
Use a 3 mm hex wrench to remove the 4 bracket screws (B) and their star washers.
On the opposite side of the fixture from the module bracket, locate the 2 tabs that
hold the module in slots on the fixture frame (C). Carefully move the module towards
the bracket side just enough to release the tabs from the slots.
Grasping the module from each side, lift it up and slide it toward the bracket and out
of the fixture (D).
Slide the new Color Mix Module into the frame guiding it between the linear slides
(E) and securing the two tabs in their slots.
5-10 General Maintenance

Figure 5-9 Removing/Installing Slot 3 module

E
D
A
B
Bracket side
C
Tab side
x.Spot Xtreme User Manual
®