Replacing A Driver Board; Figure 5-4 Lamp Optimization Screws; Figure 5-5 Driver Board Configurations - High End Systems x.Spot Xtreme Handbuch

Replacing a Driver Board

Warnings: Disconnect power before servicing.
Equipment surfaces may reach temperatures up to 130° C (266° F). Allow the
fixture to cool before handling.
The standard x.SpotXtreme fixture is designed with two basic types of motor driver
boards:
1. Interchangeable 2-phase boards drive the motors for each of the user-configured
modules, and the Focus/Frost/Zoom functions.
2. Interchangeable 3-phase pan and tilt driver boards.
Functional identification is accomplished with configuration of standoffs and contact
screws that allow for position- specific board addressing, see Figure 5-5
2-Phase Motor Driver Boards
Color Mix A (Slot 1A)
IDC
Color Mix B (Slot 1B)
IDC
Dual Rotating Gobo (Slot 2)
IDC
5-6 General Maintenance

Figure 5-4 Lamp optimization screws

x
z
y

Figure 5-5 Driver board configurations.

Gobo/Iris (Slot 3)
IDC
Focus/Frost/Zoom
IDC
screw position
standoff position
connector
IDC
3-Phase Motor Driver Boards
Pan
IDC
Tilt
IDC
x.Spot Xtreme User Manual
®