Inhaltsverzeichnis
Werbung
3. Replace the star washers and 3mm hex screws and reattach both IDC
connectors to the driver boards.
4. Reattach the bezel guiding it into the bezel channel on each yoke arm and
retighten captive bezel screws as shown in Figure 5-1 on page 5-1.
5. Place the old module in the new unit's anti-static bag for return. Include the
Return Material Authorization number (RMA#) obtained from your dealer or
point of purchase along with a written explanation of the problem or
malfunction.
Replacing Static Color Wheel Dichroic Wedges
This section describes replacing the Static Color Wheel dichroic wedges in the
x.SpotXtreme Six-Wheel Color Mix module.
Replace color wedges if they are damaged or broken, to change their order in the
wheel, or to install a new or custom color. (See "Optional Accessories" on page 1-4
for ordering information.)
To replace a color wedge:
1. Remove both sides of the bezel as shown in Figure 5-1 on page 5-1.
2. Referring to Figure 5-11, grasp the upper module frame (A) and gently push it
toward the lens as far as it will go. The static color wheel (B) is the top wheel on
the Six-Wheel Color Mix module in Slot 1 at the base of the unit.
3. Use a 2 mm allen wrench to loosen the side set screw (C) on the hub of the static
color wheel.
4. Grasping the hub, lift the wheel up and out of the fixture and place on a clean,
flat surface.
Figure 5-10 Removing the Static Color Wheel.
x.Spot
Xtreme User Manual
®
A
B
C
General Maintenance 5-11
5
Werbung
Inhaltsverzeichnis
