Assembly Instructions For Magnetic Tape With Adhesive Layer (Bml-M02 - Balluff BML-S1G0-B7-M5E-0-S284 Serie Betriebsanleitung

BML-S1G0-B/S7_ _-M5E_-_0-(SA26-)S284
Absolute Magnetically Coded Position Measuring System
4
Installation and connection (continued)
4.3.1 Assembly instructions for magnetic tape with
adhesive layer (BML-M02...)
NOTICE
Damage to the magnetic tape
Hard tools may cause damage to the magnetic surface
of the tape. Even damage that appears slight (e.g.
scratches, dents) can affect linearity.
► Do not use hard tools to install the magnetic tape!
► Replace damaged magnetic tapes!
1. Fasten the installation aid (accessory) to the left or right
side of the sensor head using screws (see Fig. 4-6).
2. Thoroughly clean (e.g. with quick rubbing alcohol) the
fixing surface for the magnetic tape to remove all oil,
grease, dust, etc. and let it dry completely.
3. Align the magnetic tape corresponding to the print (see
Fig. 3-2 on page 7).
4. Position the sensor head on the back end of the
magnetic tape to be applied (beginning of the
measuring range).
5. Remove the protective film on the rear end of the
magnetic tape and lightly apply the magnetic tape.
6. Remove another section of the protective film.
7. Move the sensor head forward a bit while applying the
magnetic tape flush with the installation aid (see
Fig. 4-7).
8. Lightly press the magnetic tape down by hand behind
the sensor head.
9. Optional: To protect the magnetic tape from
mechanical and chemical influences, affix the stainless
steel cover strip (for details, see the magnetic tape
instructions).
10. Remove the installation aid.
Machine part
Fig. 4-6: Fastening installation aid BAM TO-ML-006-S1G (order
code BAM0256) (figure shows right-sided fastening)
Installation aid
Apply the magnetic tape flush with the
installation aid
Fig. 4-7: Apply the magnetic tape flush with the installation aid
(figure with right-sided installation aid)
12 english
Ø 4.2