Accessories; Magnetic Tape; Cover Strip; Installation Aid Bam To-Ml-006-S1G (Order Code Bam0256) - Balluff BML-S1G0-B7-M5E-0-S284 Serie Betriebsanleitung

BML-S1G0-B/S7_ _-M5E_-_0-(SA26-)S284
Absolute Magnetically Coded Position Measuring System
10

Accessories

Accessories are not included in the scope of delivery and
must be ordered separately.
10.1

Magnetic tape

Absolutcode
Length
(Max. 4800 cm = 48 m)
Fig. 10-1: Magnetic tape dimensions.
BML-M0_-A55-A_-M_ _ _ _-E
Thickness
2 = Thickness 1.55, comes
with an adhesive layer
(with protective film) for
fastening
3 = Thickness 1.35, without
adhesive layer
BML-M0_-A55-A0-T4800-E
T = drum goods
Influence of magnetic tape on system accuracy (total
non-linearity)
The measuring system can achieve a system accuracy of
±20 μm.
For a complete technical description and
assembly instructions for magnetic tapes,
please see the magnetic tape user's guide in the
Internet at www.balluff.com/downloads-bml.
10.2

Cover strip

To protect the magnetic tape from damage caused by
chips or chemicals, you may cover it using a stainless steel
cover strip. Note that the permissible gap between the
sensor head and tape is reduced by the thickness of the
cover strip with adhesive layer (0.15 mm)
(Tab. 4-1 on page 8).
Before affixing the cover strip, carefully clean the surface of
the magnetic tape (acetone, turpentine, mild plastic
cleaner, no benzine).
If magnetic tape BML-M0-A55_-A3-M... is
ordered, a cover strip in the same length is
included in the scope of delivery.
www.balluff.com
10+0.2
1.55±0.1 (BML-M02...)
1.35±0.1 (BML-M03...)
Cover strip Length
0 = No cover in cm
strip
3 = With cover
strip
The cover strip can be ordered as drum goods in 4 defined
lengths.
Thickness incl. adhesive
Width
Length Ordering code
BML-A013-T0500 BML001J
BML-A013-T1000 BML001K
BML-A013-T2400 BML001L
BML-A013-T4800 BML001M
For a complete technical description and
assembly instructions for cover strips, please see
the magnetic tape user's guide in the Internet at
www.balluff.com.
10.3 Installation aid BAM TO-ML-006-S1G
(order code BAM0256)
56.5
32
25
3.5
Fig. 10-2: Installation aid
10.4 BML Configuration Tool BAE PD-ML-010-03
(order code BAE00UN)
The Configuration Tool allows the measurements, BEF
number, and error messages to be read out from the BML
sensor head.
At the same time, the sensor head can be parameterized
with the Configuration Tool (changing between BiSS and
SSI, resolution, etc.)
Ring applications (see sec 4.1.3 on page 10)
must be calibrated with the Configuration Tool.
Approx.
0.15 mm
10 mm
5 m
10 m
24 m
48 m
4.2
75
english 31