Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
BCM R15E- _ _ _ -DI00- _ _ , _ -S4
Condition Monitoring Sensor
The CE Mark verifies that our products
meet the requirements of the current
EMC Directive.
Intended use
The Condition Monitoring Sensor (BCM) together with a
machine controller (such as a PLC) or an Edge gateway
together with an IO-Link master forms a condition
monitoring system. It is intended for temporary or
permanent use installed in a machine or system and used
in the industrial sector. Flawless function in accordance
with the specifications in the technical data is ensured only
when using original Balluff accessories. Use of any other
components will void the warranty.
Opening the BCM or non-approved use are not permitted
and will result in the loss of warranty and liability claims
against the manufacturer.
General safety notes
Installation and startup may only be performed by
qualified personnel with basic electrical knowledge.
The operator is responsible for ensuring that local safety
regulations are observed.
In particular, the operator must take steps to ensure that a
defect in the BCM will not result in hazards to persons or
equipment.
If defects and unresolvable faults occur in the BCM, take it
out of service and secure against unauthorized use.
Downloading further instructions
A detailed user's guide can be downloaded from the
Internet at www.balluff.com or requested via e-mail from
service@balluff.de.
orange LED
6.7
Membrane
26
32
1
english
All manuals and user guides at all-guides.com
1)
1)
green LED
2
Dimensions and function
The BCM is an intelligent condition monitoring sensor. It is
used for acquiring condition information for a system or
machine and for monitoring trends. It cannot replace a
precision measurement system for determining condition.
LED
Color
State
Green
On
Inverse flashing
(1 Hz), t
:t
= 9:1
on
off
Alternating flashing
4 Hz/2 Hz
Orange
1)
Flashing
(2 Hz, 10 s)
The display duration for an event triggering is
extended by 10 s if a further event is triggered
during that time.
The Ping function makes it possible to identify the BCM via
an optical signal after it is connected to an IO-Link master.
Electrical connection
Pin
Wire color
Signal
1
Brown
+24V (operating voltage UB+)
3
Blue
GND (operating voltage UB-;
reference potential)
4
Black
C/Q (IO-Link)
1
Pin assignments for connector (pin
4
side view)
3
46
1) only for BCM R15E-002-...
Operating state
IO-Link communication
inactive
IO-Link communication
active
PING function active
Event triggered
Werbung
Inhaltsverzeichnis
