Set In Function - Lachinger 2200/S05 Gebrauchsanweisung

SET IN FUNCTION

The operator following controls positive result finalized to check the respect of all safety conditions and of all controls of the
previous paragraph, can set in function the machine, following in order the under showed indications.
The food ingredients must be loaded manually in the bowl, with the open moving shelter. During the machine functioning
some ingredients can be added also with the closed moving shelter during the bowl functioning, in the versions with not full
shelter.
The ingredients and the packaged products must be handled with care, reducing at minimum the height over the
bowl base from which are poured out. The packagings must be opened with care in the bowl inferior part to
favor the flour dust release in the less possible time.
1. After the interblocked moving shelter closure and the machine starting, the bowl and tool rotation allows amalgamating
in uniform way the mixture up to the desired consistency.
2. When the mixture has reached the desired consistency or after the programmed functioning time, the bowl and the tool
stop and the operator, opening the interblocked moving shelter or lifting the machine head, performs the drawing of the
kneaded product from the bowl. The bowl can be removed to facilitate the unloading operations of the kneaded product.
3. The manual operations of product samples taking can happen with appropriate tools or with the closed moving shelter (if
foreseen of the appropriate opening), or with the opened moving shelter.
All machine parts addressed to come in contact with the food products, as bowl, tools, spacca pasta, etc... are in stainless steel
materials or plastic material addressed to come in contact with the food.
It is recommended to make not function the vacuum machine, without the food product.
SET IN FUNCTION ART. 2500
To start the machine, as seen, it is possible to choose between two modalities:
1° Manual way:
The working lasts up to when it isn't interrupted from the user;
Set the speed, "slow" or "fast", desired for the rotation;
Push the button of ON, to start the working.
2° Automatic way:
The working lasts in function of the time set from the user (it can however be interrupted in every
moment);
The cycle works with the logic to perform before the working phase with the "slow" speed for its set
time, so the working phase with "fast" speed for its set time;
Include or exclude the desired rotation phases with "slow" or "fast" speeds (possibilities: SLOW +
FAST, ONLY SLOW, ONLY FAST);
Set for each of the included speeds the desired working time;
Push the button of ON, to start the working.
10-2009-IMPASTATRICI-A5.doc
ORIGINAL INSTRUCTIONS TRANSLATION
Pag. di
24 31