Configurations; Service Conditions - Lachinger 2200/S05 Gebrauchsanweisung

3.3.

CONFIGURATIONS

For the detailed technical data, the production and the mechanical drawings, cfr. annexed.
TECHNICAL DATA
FIXED HEAD
TIP UP HEAD
FIXED BOWL
REMOVABLE BOWL
ROUNDED BOWL EDGE
FLAT EDGE BOWL EDGE
SPIRAL TOOL
SPATULA TOOL
FIXED TOOL
INTERCHANGEABLE TOOL
UNIQUE MOTOR FOR BOWL AND TOOL
A MOTOR FOR BOWL AND ONE FOR TOOL
THREE-PHASE MOTOR
TWO SPEEDS THREE-PHASE MOTOR
MONOPHASE MOTOR
ELECTROMECHANICAL CONTROLS
ELECTRONIC CONTROLS WITH
DELAY TIMER
ELECTRONIC CONTROLS WITH TIMER FOR
SPEED SWITCHING
3.4.

SERVICE CONDITIONS

DATA
Level of acoustic power continue equivalent weighted
A
Current nature – Frequency
Current full charge value
Use nominal voltage
Allowable presumed current of nominal short circuit
conditioned
Mass and neutral
Protection degree
Machine positioning
Use place
Maximum temperature of the work environment air
Requested minimum lighting
Further use conditions
PROTECTION DEVICE RECOMMENDED AGAINST THE OVERCURRENTS
Insulation nominal voltage
Nominal current
Magnetic relay setting
Thermal relay setting
Maximum value of the damage ring impedance
10-2009-IMPASTATRICI-A5.doc
ART. 2200 ART. 2200 TOP
STOP
ART. 2200 - ART. 2200 TOP – ART- 2400 – ART. 2500
Work bench used in the food field of height included
between 900/1100mm from the trampling floor of adequate
capacity, in which it is possible to circulate freely around the
machine with a free space of at least 800mm
Inadequate machine for functioning in environments where
there are contaminated agents: for example powders, acids,
corrosive gas, salts and similar.
Inadequate machine for functioning in environments where
there are potentially explosive atmospheres classified as zone
0 or zone 1 or zone 2.
Inadequate machine for functioning in environments where
there are ionized and not ionized radiations: for example
microwaves, ultraviolet rays, lasers, X rays and similar.
Inadequate electric equipment to be equipped with machines
or to function in environments where there are vibrations and
shocks: in contrary case assembly it far from the device and
foresee antivibrating supports
ORIGINAL INSTRUCTIONS TRANSLATION
ART. 2400 ART. 2500
Minor of 70dBA
Cfr. machine plate
Cfr. machine plate
Cfr. machine plate
6 kA symmetric
TT e TN
IP X3
Inside
+40°C
500 lux
Ui = > 690 V
In = > see electric diagram
Im = < see electric diagram
Ir = see electric diagram
0.1 Ω
Pag.
9
di
31