Preparation; A) Scope Of Delivery, Necessary Accessories - Reely RAMBO Racing 7.5 RTR Bedienungsanleitung

4wd gp buggy 1:6

Inhaltsverzeichnis

Verfügbare Sprachen

Preparation

Scope of delivery, necessary accessories

Scope of delivery

One Chassis

7,54 ccm two stroke glow engine

with ,4 kW (3,3 HP),

with manifold, resonance tube and air filter

-speed drive with metal cogwheels

Clutch bell with aluminium clutch cheeks

Steering servo, Throttle/brake servo and receiver,

already mounted

fuel hoses, already laid.

Four wheels with plastic rims and

already mounted tires with linings

Buggy car body, imprinted

Splints to fasten car body

A plastic tube as guidance for the wire aerial

one three-channel remote control

(pistol grip transmitter)

This operating manual

Spare Parts

The spare part list can be found on our Website www.conrad.com in the Download domain specific to the corresponding prod-

uct. Alternatively, you can order the spare parts by phone; the contact details are at the beginning of this operating manual in

chapter "Introduction".

Accessory recommendation

Which type of fuel is the right one?

The selection of the fuel has an impact on the performance characteristic of the engine.

However, as a matter of principle:

In the running-in phase, a special RC car fuel with approximately 16% nitromethane should be used.

After the run-in of the engine (after a mere operating time of approximately 45 minutes), you can change to a fuel with approximately 0% nitrome-

thane.

For maximum output, we recommend the max. percentage of 5% nitromethane

Use fuel for RC cars only!

The percentage of oil contained in fuel for RC plane engines is too small (too little lubrication), which causes the

engine to overheat, thus leading to serious damages.

The same is valid for vehicle gasoline.

Why is a tank bottle needed?

RC model car fuel is available in big bulks (canisters) only. Filling the tank by using a smaller, special tank bottle with a small, curved pouring tube is

significantly simpler. You also prevent spilling fuel (expensive and poisonous).

Are more glow plugs necessary?

Glow plugs wear, especially in the running-in phase. Therefore, we recommend having some glow plugs ready in case of need for a replacement.

There are glow plugs with different calorific values; the selection of the glow plug has a big impact on driving performance. For the running-in phase,

you should use a "hot" glow plug for high performance engines. After the running-in phase, you can use a glow plug with a middle or a "cold" calorific

value.

Use glow plugs for RC cars only! A wrong glow plug, such as e.g. for 4 stroke plane engines, lets the engine run incorrectly and

complicates the tuning.

Replacing the glow plug

To that effect, you need an extra long plug spanner (spider wrench SW 8, 9, 10 and 1), which can be used also to unscrew the outer hexagonal

screws.

Preheating the glow plug

A plug connector (long) with rechargeable battery as a unit is inserted on the glow plug and heats the latter, so that the air-fuel mix sparks off and the

engine starts. When the engine runs smoothly, the plug connector can be removed.

Required accessories

Not included in the delivery:

1 accumulators for the transmitter and the receiver

Glow plug and

plug spanner

Plug connector with rechargeable battery as a unit and

battery charger

Tank bottle

Also available as a complete set

Nitrobox II Combuster no. 23 07 99

incl. transport box