K) Function Of The Cockpit Led; Trimming The Helicopter - Reely PRO Bedienungsanleitung

k) Function of the cockpit LED

• An LED with blink electronics is connected parallel to
the front drive engine.
This LED serves as "position" light and starts to blink
as soon as the engines are supplied with voltage.
• The LED does not serve as voltage indicator for the
battery!
Stop flying immediately as soon as you notice that the engine power is declining. This is the
only way to prevent the deep discharge of the LiPo accumulator.
l) Trimming the helicopter
• Push the Pitch stick (see figure 1, Pos. 10) from the bottom position (engine off) carefully forward and observe the
response of your model. Shortly before the helicopter starts hovering, you can already determine in which direction
your model wants to move.
• If the helicopter wants to turn to the right with the tip of the fuselage, then reduce the speed and push the steering
trim for the Tail function (see figure 1, Pos. 9) gradually to the left.
• Push the Pitch stick carefully forward and check if the adjustment was sufficient. Keep repeating this procedure until
the helicopter no longer has any tendency to turn to the right.
• If the tip of the fuselage turns to the left, carry out a right trim adjustment.
Figure 14
Figure 13
53