Before Operation; During Operation - Reely PRO Bedienungsanleitung

b) Before operation
• Make sure that no other models are operated within the range of the remote control on the same remote control
channel (transmitter frequency). Otherwise, you will lose control over the remote-controlled model! Always use
different channels if you wish to operate simultaneously two or several models in the immediate proximity of each
other.
• Check the function safety of your model and of the remote control system. Pay attention to visible damages such as
broken plug-in connections or damaged cables. All movable parts on the model have to be smooth running; however,
there must be no tolerance in the bearing.
• Charge the flight battery, which is necessary for operation, as well as the rechargeable battery needed in the remote
control according the instructions indicated by the manufacturer.
• As power source for the plug-in mains unit, use a 230V/50 Hz mains socket of the public mains only. Never try to
operate the device at another voltage.
• If batteries are used for the power supply of the transmitter, make sure that there is a sufficient rest capacity (battery
checker). If the batteries are empty, always replace the complete set, never individual cells only.
• Before each operation, control the settings of the trim slider at the transmitter for different steering directions and, if
necessary, set them.
• To operate your model, always pull out the telescopic antenna to its full length as otherwise the transmitters presents
a considerable lower range and the transmitter output is strained higher than average.
• Always switch the transmitter on first. It is only afterwards that the flight battery of the helicopter may be connected
to the receiver/regulator unit. Otherwise, the electric-driven helicopter can have unpredictable reactions.
c) During Operation
• Do not take any risks when operating the product! Your own safety and that of your environment is solely down to
you being responsible when dealing with the model.
• Improper operation can cause serious damage to people and property! Therefore, during operation, ensure a sufficient
safety distance to persons, animals and objects.
• Fly your model only if your ability to respond is unrestricted. The influence of tiredness, alcohol or medicine can
cause incorrect responses.
• The motor, the receiver/regulator unit and the flight battery can heat during operation. Therefore, take a break
before re-charging the flight battery or before flying with a possibly available spare flight battery. Especially the two
engines must cool down to room or ambient temperature.
• Always leave the remote control (transmitter) turned on, as long as the model is in operation. After landing, always
disconnect the flight battery for the receiver/regulator unit first. It is only afterwards that the remote control may be
turned off.
• Don't expose your model and the remote control for a longer period of time to direct sunlight or excessive heat.
38