I) Modifying The Push Stick Assignment Of The Transmitter - Reely PRO Bedienungsanleitung

i) Modifying the transmitter-push stick assignment
• If you want to fly with the pre-set stick assignments described
above, then you can ignore this chapter. However, if you wish to
exchange the control of the throttle and nick function at the
transmitter, you have the possibility to carry out modifications on
the transmitter.
• To this effect, unscrew the antenna of the transmitter (see figure 1,
Pos. 1) and remove the battery compartment (see figure 2, Pos.
2) from the casing.
• Unscrew the four screws by means of a Phillips-tip screwdriver
from the rear panel of the transmitter and lift the rear panel carefully.
Remove the contact plug of the LED display (see figure 12, Pos.12)
from the main board.
• Unscrew (seen from behind) the two outer screws at the left stick
unit (1 and 2) and on the inner side, the upper screw (3). Screw (4)
must be loosened only slightly to prevent a fall of the stick unit.
• Lift the complete stick unit so that you can remove the left lateral
panel with reset lever and reset spring (5) from the guiding rails.
Push the stick unit without the lateral panel back into its original
position.
• Unscrew (seen from behind) both upper screws (6 and 7) at the
right stick unit and, on the outer side, the lower screw (8) with the
stop spring (9).
Screw (10) must be loosened only slightly to prevent a fall of the
stick unit.
• Lift the complete stick unit so that you can remove the right late-
ral panel without reset mechanics (11) from the guiding rails.
• Take the lateral panel with reset mechanics of the left stick unit
and place it mirror-inverted at the right unit and push the stick unit
back into its original position.
Make sure that all four lateral panels are correctly guided in
the corresponding rails and that the steering trims (see fig. 1.
Pos. 8 and 9) are correctly placed in the openings of the
casing.
Finally check the mechanical function and screw firmly the stick
unit.
Figure 12
51